Cable tester for RJ45 and BNC with remote unit

LogiLinks cable tester for older BNC network cables and RJ45 recent patchkabel. With the associated remote unit, you can test a complete line after installation. Easy to use, display via LEDs for testing RJ45 and BNC according to valid standards. The unit checks all pairs and shielding, if a signal is successfully passes from one side to the other.

Cable Tester for RJ11/RJ12/RJ45 & BNC

Master & remote unit

Suitable for Patch- and BNC cables

Various LEDs for status:

Loop-Back: localization of laid network cables

Continuity: of network or communication cables

Open: disconnected single wires

Shorts: short circuited single wires

Miss-Wire: identification of non conform wire assigment, Powered by 1x 9 Volt block battery (not included)